SF6 Gas Handling Equipment

DILO SF6 Gas Compressor

High-pressure compressor for recovering SF6 to liquid storage, allowing large gas volumes to be held in a fraction of the cylinder space.

Share This Product :

The compressor is the component that makes large-volume SF6 recovery practical. Recovered gas is compressed to the point of liquefaction and stored as a liquid, so a large substation charge occupies a fraction of the cylinder volume it would need as gas.

Where it earns its place

  • GIS substations, where a single bay can hold hundreds of kilograms of SF6
  • Decommissioning and refurbishment, where a whole installation must be emptied within an outage window
  • Service centres handling gas from multiple sites

The practical constraint

Recovery time is usually the binding limit on an outage. A compartment that takes a day to empty with an undersized unit and two hours with the right one changes what can be scheduled into a single shutdown — and outage hours on a transmission substation are worth considerably more than the difference in equipment cost.

Send the total gas mass to be recovered and the available outage window with your enquiry.

No additional information.

Need a quotation for this product?

Send us your specification and we route the enquiry straight to the manufacturer’s export team. Requesting a quotation through IndusGrove is free.

Independent listing. IndusGrove is an independent B2B directory for the power, electrical and renewable energy industry. We are not a distributor, agent or authorised reseller for the manufacturers listed here, and we do not hold stock. Manufacturer names, brand names, model numbers and trademarks are the property of their respective owners and appear here for identification and reference only.

Product information is compiled from publicly available manufacturer sources and may change without notice. Verify all specifications, ratings and compliance data with the manufacturer before purchase. Enquiries submitted through this page are referred to the manufacturer or its authorised channel.

Manufacturers may request an amendment or the removal of any listing at [email protected].