High Voltage Testers

Metrel MI 3215 TeraOhmHP 15 kV Insulation Tester

High-power portable insulation resistance tester with adjustable DC test voltage from 50 V to 15 kV, measurement to 35 TΩ, PI/DAR/DD diagnostics, step and withstand voltage tests, CAT IV 1000 V and IP65.

Share This Product :

Metrel MI 3215 TeraOhmHP 15 kV

The MI 3215 TeraOhmHP is a high-power, portable, battery or mains powered insulation resistance tester for diagnostics using DC test voltages up to 15 kV. Its dual-case construction, IP65 rating and CAT IV 1000 V (to 3000 m) safety rating make it suited to substation and industrial field work rather than laboratory use.

Measuring functions

  • Insulation resistance measurement up to 35 TΩ
  • Diagnostic tests: Polarisation Index (PI), Dielectric Absorption Ratio (DAR) and Dielectric Discharge (DD)
  • Step voltage test
  • DC withstand voltage test up to 15 kV
  • Voltage and frequency measurement up to 999 V TRMS
  • Capacitance measurement

Key specifications

  • Adjustable test voltage from 50 V to 15 kV in 50 V and 100 V steps
  • Maximum short-circuit / charging current > 6 mA
  • Charging rate into capacitive load < 4 s per µF at 15 kV on mains supply, 6.3 s per µF on battery
  • Discharge rate < 1.6 s per µF at 15 kV
  • 4400 mAh Li-ion battery
  • 8 GB SD card memory
  • Burn / breakdown mode with high-voltage breakdown detection
  • Automatic discharge of the test object on completion; live voltage detection above 30 V
  • Coded, locking banana connectors and HV crocodile clips

Why the diagnostic tests matter

A single spot insulation reading says little about an ageing machine or cable. PI and DAR reveal moisture and contamination by comparing resistance over time; DD identifies degradation in multi-layer insulation that a spot test will pass. On rotating machines and MV cables these time-based tests are the ones that actually predict failure.

Applications

MV and HV cable insulation testing, generator and large motor winding diagnostics, transformer insulation assessment, surge arrester and bushing checks, and acceptance testing on new installations.

No additional information.

Need a quotation for this product?

Send us your specification and we route the enquiry straight to the manufacturer’s export team. Requesting a quotation through IndusGrove is free.

Independent listing. IndusGrove is an independent B2B directory for the power, electrical and renewable energy industry. We are not a distributor, agent or authorised reseller for the manufacturers listed here, and we do not hold stock. Manufacturer names, brand names, model numbers and trademarks are the property of their respective owners and appear here for identification and reference only.

Product information is compiled from publicly available manufacturer sources and may change without notice. Verify all specifications, ratings and compliance data with the manufacturer before purchase. Enquiries submitted through this page are referred to the manufacturer or its authorised channel.

Manufacturers may request an amendment or the removal of any listing at [email protected].